100W JPT MOPA EM7 · MOPA fiber laser
Laser Materials Library
Test grids from my fiber laser, one material at a time. Every cell is a setting, and every setting gets a color, so I can design pieces in color and know what the laser will actually give me.
Unless a test says otherwise: 100 mm lens, 0.1 mm line interval, 1 pass, run from LightBurn.
Materials
-
Slate
Low energy turns slate a soft grey and nearly white. More takes it through beige and tan to gold, which an 80 ns pulse reaches without melting. Push past a slight satin sheen and it melts: the surface rises, then bubbles into glossy bronze, and both damage the slate.
More materials as I test them. Each one gets its own tab with the same columns; here's a blank template.
The laser
A 100W JPT MOPA EM7, a MOPA fiber laser. MOPA means the pulse width can change as well as the frequency, which is a big part of how it makes different colors on the same material.
- Average power
- 100 W
- Wavelength
- 1064 nm
- Maximum pulse energy
- 1.5 mJ
- Frequency range
- 1–4,000 kHz
- Pulse widths
- 16 fixed steps from 2 to 500 ns, plus CW
- Lens
- 100 mm
Pulse widths and full-power frequencies
The source runs only these pulse widths. Each reaches full power only above its cut-off frequency; below it, output drops. That's worth knowing before reading any grid run at a low frequency.
| Pulse width | Full power from | Highest frequency |
|---|---|---|
| 2 ns | 2960 kHz | 4000 kHz |
| 4 ns | 2160 kHz | 4000 kHz |
| 6 ns | 1400 kHz | 4000 kHz |
| 9 ns | 960 kHz | 4000 kHz |
| 13 ns | 680 kHz | 3000 kHz |
| 20 ns | 420 kHz | 3000 kHz |
| 30 ns | 300 kHz | 3000 kHz |
| 45 ns | 250 kHz | 2000 kHz |
| 60 ns | 200 kHz | 2000 kHz |
| 80 ns | 180 kHz | 2000 kHz |
| 100 ns | 160 kHz | 1000 kHz |
| 150 ns | 95 kHz | 1000 kHz |
| 200 ns | 75 kHz | 1000 kHz |
| 250 ns | 70 kHz | 900 kHz |
| 350 ns | 67 kHz | 600 kHz |
| 500 ns | 67 kHz | 500 kHz |
Source: JPT YDFLP-E-80&100-M7-M-R User Manual (100 W model).